Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 10/31/2003 12:42:36 PM EDT
I just aquired a bull barrel and would like to install my harris bipod. what is the easiest way to install this to it? (do I have to drill a hole in the FF handguards?)

Thanks
Link Posted: 11/3/2003 2:21:59 PM EDT
If it is an aluminum FF tube, just drill a hole and install a swivel stud to mount the Harris.
Link Posted: 11/3/2003 2:29:39 PM EDT
Thanks Do I have to remove the handguards, or just drill with it attached to the receiver? If i have to remove it how do you go about doing that?
Link Posted: 11/3/2003 5:08:05 PM EDT
It's probably easiest to leave it on. Use a drill press, or a hand drill with a short bit so you don't go too far and hit your barrel.
Link Posted: 11/3/2003 5:10:23 PM EDT
BSBG Thank you for the help. once the hole is drilled do i just screw the harris stud into the handguard (so dill the hole a little small) or do you use a nut on the inside of the handguard?
Link Posted: 11/3/2003 5:39:21 PM EDT
I'd feel a lot better with a nut and some Loctite on the back [;)].
Top Top