AR Sponsor
Posted: 7/24/2010 7:41:38 AM EDT
|
Does anyone know if the standard mount holds its zero? I put witness marks on the thumb screws and on the upper but haven't taken it off yet to check. I don't plan on removing it often, just to clean the rifle. Thanks
Edit. I have a TA31 if it matters |
|
In their operator manuals, I believe Trijicon says their optics will return to zero if the thumbscrews are torqued to the same spot.
I don't know, but I would guess that in order to achieve best results, you should torque the thumbscrews in the same way each time (i.e. hand tight rear, hand tight front, then a quarter turn more rear and a quarter turn more front). I'm sure there are more people with good knowledge of the TA51 mount around though. |
|
I have never Shot moa groups with any of my acog equipped rifles, But as far as I can tell poi doesnt change, I have taken the scope off cause people want to look through it and I don't feel like unclipping the sling.......
Once it is reattached I would not hesitate to take a critical shot on a target, it is very repeatable......I am 100% confident in it..... |
AR Sponsor