Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
AR Sponsor
5/18/2003 1:25:43 PM EDT
I've been fortunate enough to acquire a Leupold LR M3 scope.  I have it mounted on a Bushmaster Varminter using ARMS #21 rings on a #35.  This is my first experience with a variable power scope and to be honest, I'm in over my head.  Are there any general rules about what power to use at what range?  I know everyone is different but I at least want to be in the ballpark.  Also, I have boresighted it and I've got it tuned at 25 yards.  What is the proper distance to sight this scope.  I plan on shooting between 100 and 200 yard distances.  Any help, to straighten me out, would be appreciated.
Thanks...Tim  
5/18/2003 2:06:19 PM EDT
[#1]
Sight it in at 100 yards at least, longer is better because you can judge if the windage is off a bit better at that range.  I leave the scope at 3.5X and just crank up the windage to whatever I think is appropriate when I get ready to make a shot.  That is usually full power unless its at night and then I try to keep 7-8mm exit pupil for low light viewing.

For example at dusk 6X will give me just under a 7mm exit pupil. 5X gives a 8mm exit pupil.  If its kind of dark but not quite dusk I just zoom until I notice the piture get dark and back off.  Also just judge how fast the target can move and be sure to keep the whole target in the scopes field of view while tracking a moving target.  You can zoom in tighter on a slower moving animal at a given range.
5/18/2003 9:57:58 PM EDT
[#2]
DevL's advice is great, as usual.  As a rule, you always keep your scope set at the LOWEST power unless you're specifically setting up a long-distance shot.  The low setting give you the largest field of view and the brightest image, making it far easier to quickly aquire the target.  You only adjust the scope when you have plenty of distance, which gives you time and safety.

If you have a Mil-Dot reticle, remember that it is only calibrated when at MAX magnification!

-Troy
5/19/2003 11:29:56 AM EDT
[#3]
Thanks DevL and Troy.  All info is very helpful.  By the way I do have the Mil-dot and will sight at highest power.

Thanks again!
Tim
5/19/2003 11:42:12 AM EDT
[#4]
Quoted:
If you have a Mil-Dot reticle, remember that it is only calibrated when at MAX magnification!
-Troy
View Quote


Un-less ya happen to get one of [b]Premier Recticles[/b], Leupolds w/ the new Gen II mil-dot scopes, which have the dots in the first plane and adjust for the power your at..... very nice recticles, IMO.

Mike

5/19/2003 3:41:32 PM EDT
[#5]
Correct.  Many European scopes are also this way, but most American scopes have to be on max magnification for the Mil-Dot scale to work properly.

-Troy
5/20/2003 4:40:40 AM EDT
[#6]
T-blaster,

I just wanted to say, "Nice rig".

Dave S
AR Sponsor