AR Sponsor
Posted: 3/7/2008 1:42:12 PM EDT
| How hard is it to change out a standard floor plate for one of these? Are there any pictures/instructions on how to do it? Thanks |
|
Very easy! Remove the old floor plate - I use a punch because it fits in the hole. Put in the new base plate - the "bullet" in the raised center should point towards the front. Use the Ranger Loop part to hold down the base plate. It should be about 75-85% on so that you only slide it a short distance to engage the four tabs on the bottom of the magazine with the SS tabs on the bottom Ranger Loop. If done correctly the "bullet" engages the hole in the middle and the tab on the backof the base plate locks the back of the Ranger loop. After you figure out the first one, the next 99 go very quickly. |
AR Sponsor