Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 7/12/2003 7:26:05 PM EDT
I was trying to remove the floorplate and kinked the spring up insde the mag body.The floorplate will not slide off.
I think it will go up on the firing line the next time I'm out shooting!
I will never buy any steel ProMags again!
Link Posted: 7/12/2003 9:27:43 PM EDT
reb. I put a bevel on the sides of my 2nd. gen. Pro Mag AR floorplates after I removed them. Makes it alot easier to disassemble next time. They bent the tabs to tight on the 2nd. generation AR mags. The first generation mags are far better mags but have'nt been around since the ban. Call Pro Mag and complain maybe they'll send you some free springs and floor plates, I hear their pretty good about that.
Top Top