AR Sponsor
Posted: 11/29/2011 4:38:28 PM EDT
| Ok all the great things i have heard about these i ordered three and just tried them out today and no good. Would not strip a round out of the mag rounds were hard to load so i looked at the feed lips and they looked smaller than my CMMG mag so i measured them and they were. Anybody else had this problem i ordered them from 44Mag should i contact them or BlackDog. Thanks Mike |
|
Quoted:
Contact Black Dog. I believe there was a run of out of spec feed towers. (don't quote me) Kevin will take care of you. If you think it would be quicker, contact 44 mag. Dave N Thanks just sent an email to BlackDog and from my previous thread the winchester 525 bulk pack ran perfect. |
|
Told you in the exchanged PM's, BDM has no problem with replacing defective products. It's good that
you put this in the public forum so others will know. There was a problem with some of the initial run. Kevin sat down personally and verified it's existence so it would be quickly fixed. Guess a few of the first batch did get out. One that I had for testing fell into this category. Racheal sent a new tower out to me and that fixed the feed issues. Now that mag runs 100%, even Full Auto.... 
Dave N |
|
Quoted:
Told you in the exchanged PM's, BDM has no problem with replacing defective products. It's good that you put this in the public forum so others will know. There was a problem with some of the initial run. Kevin sat down personally and verified it's existence so it would be quickly fixed. Guess a few of the first batch did get out. One that I had for testing fell into this category. Racheal sent a new tower out to me and that fixed the feed issues. Now that mag runs 100%, even Full Auto....
Dave N Yeah I got one with a bad feed tower too but I was able to clean the inside up with a dremel and it is working just fine. I also bought 2 xtra feed towers made out of the polymer material just to see how they work but fit a little loose within the mag body, that caused a few misfed rounds. I'll stick with the st steel unit. |
AR Sponsor