[ARCHIVED THREAD] - Stock question

Posted: 12/28/2002 3:51:47 PM EDT

I just installed a collapasable stock onto my preban Colt 9mm. It installed fine but I am wondering if I need to buy a 9mm buffer and spring for this stock or will the .223 buffer and spring that is came with work? I would think that it is ok but figured I would ask for someone elses opinion.

Thanks

Posted: 12/28/2002 6:21:00 PM EDT

[#1]

I dont KNOW the answer to that question, but I did the same thing about two days ago and the gun ran fine with the same spring and buffer that was used on the fixed stock that came with the gun.
Wait, is this an upper or a whole Colt 9mm rifle ?

Posted: 12/28/2002 7:24:07 PM EDT

[#2]

444-My rifle is a complete Colt PreBan 9mm. I don't know if there is enough room to install the old buffer into the collapasable stock or not.

Posted: 12/29/2002 1:29:21 AM EDT

[#3]

It will work with the .223 CAR buffer and CAR spring.

The buffer is actually different between the .223 and the 9mm (9mm one is heavier).

see:

[url]www.biggerhammer.net[/url]

I've heard that:

Semi auto no problem, though at F/A it WILL MAKE A DIFFERENCE.

Posted: 12/31/2002 11:29:42 PM EDT

[#4]

If you had a full length stock on your 9mm before you put the collapsible stock on it, then you should be using the regular CAR buffer and spring that would go with the collapsible stock. You cannot use the buffer that went with a full length stock. If you are shooting in semi auto only, then you do not need the heavier 9mm buffer. The reason for using a heavier buffer is to slow down the rate of fire in full auto. I use both the regular CAR buffer and the heavier 9mm buffer. It depends on how fast I want the rate of fire to be. But again, this is in full auto.

Charles Tatum
Alamo Professional Arms

[ARCHIVED THREAD] - Stock question

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Stock question

[ARCHIVED THREAD] - Stock question