AR Sponsor
Posted: 8/21/2016 11:07:54 AM EDT
|
I installed this kit on my AR. The threaded pin is
about a 32sd longer so there's some movement left or right when I push on it. That being said the connector rods do not lay flat against the lower. Is this kit supposed to fit that way? |
| They are a tad bit longer than the thickness of the receiver. I had to take a few swipes with a file and remove a few thousandths of an inch from the length of the pins. Leave it so you have like a thousandth or two above the surface of the receiver and you should be good to go. Do a few light swipes then try out. Don't over do it. |
AR Sponsor