AR Sponsor
Posted: 8/14/2014 4:24:41 PM EDT
|
I have the retro Colt/Tasco rubber coated scope from a Colt Delta Elite AR. The scope has the fixed flat rail attached to its underside, instead of the two rings that typically hold a scope in place. Where do I find the four clips and the screw to secure the bottom rail of the scope to the top rail of the Colt A1 vintage scope mount that attaches to the carry handle? I hope this is clear in my explanation as I wonder why so many reads with no reply...
Mike |
)
| That part is really hard to find. I have the delta ARMS carry handle mount but have only seen that part sold with the scope - and they are rare. I think the clips themselves are Weaver parts that were refinished with that finish for Colt, but don't remember where I heard that. |
| I have 3-9x and 4x Tascos with the built in rails. Thank goodness they came with all the parts. If I needed a replacement, I would check out Burris. The attachment method they use on the Eliminator scopes is very similar to the old rubber armored Tascos. Then I would replace the knobs with those from older weaver scope rings. |
AR Sponsor