AR Sponsor
Posted: 1/19/2013 6:44:04 PM EDT
|
I posted a picture of an engraved NDS receiver and Brick moderator in another thread yesterday and have had a few PM's asking about them. They were all done by Ident Marking a year or two ago. They are holding up well, but if a lot of CLP is used the color fill will fade. A little alumi black (even though the receivers are grey) refills them. Just painting it in the engraving, let it sit for a few seconds, wiping off, retores them. Don't let it remain on too long or you can darken the grey anodizing where it touches.
This is the photo I sent and the result:  
This is the photo I sent and the resulting moderator. The serial number is made up: 0350  
Here is another receiver done a little different: 
Here are two of the rifles and the carbines the receivers are on: 
|
AR Sponsor