[ARCHIVED THREAD] - engraving lower unit for NFA

Posted: 5/6/2009 2:31:55 AM EDT

Does anyone have a metal engraver they use in the St. Louis area to engrave their lower units for SBR's?? Thanks for the help in advance.

Posted: 5/6/2009 3:36:36 AM EDT

[#1]

You'd probably have better luck posting in the Class 3 forum.

Posted: 5/6/2009 6:51:19 AM EDT

[#2]

Do you have to do that?

Posted: 5/6/2009 7:19:53 AM EDT

[#3]

Quoted:

Do you have to do that?

If you make an SBR on a form 1 you do. You are the manufacturer of the SBR and your info needs to be on it.

Posted: 5/6/2009 8:01:06 AM EDT

[#4]

I have used quentin laser in AZ for mine and just sent it off. Very good work. I have also seen work done by orion. The cost is very reasonable and it is to the correct specs required. Quentin just does on the side of the receiver, orion will do by trigger and front of mag well also. Much better than the local trophy shop as they make sure it is deep enough and done right to NFA specs

http://www.orion-arms.com/new/
http://www.quentin-laser.com/catalog.html

Posted: 5/9/2009 5:25:08 PM EDT

[#5]

Thanks for the input.

[ARCHIVED THREAD] - engraving lower unit for NFA

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - engraving lower unit for NFA

[ARCHIVED THREAD] - engraving lower unit for NFA