AR Sponsor
Posted: 2/7/2009 8:10:19 AM EDT
I was sitting on my favorite log this morning overlooking my favorite pasture with my AP4. As I was admiring the Panther, I started to think that maybe I'd like to swap the free float aluminum tube for a rail system.........or maybe even remove the tube to clean the carbine if I ever had it out in wet weather. Then it hit me.......how do I remove the tube? Must I remove the barrel? How about Removing the FSB? I hope there is an easier idiot proof "did you make sure there was gas in it" solution that I'm too dense or inexperienced to see? 
Also, anyone recommend a decent quad rail system for it for a couple hundred bucks? |
|
The DPMS FFT is 2 pieces. The barrel nut piece is the 1.5" closest to the receiver. The remainder is a threaded tube that screws onto the barrel nut. If you look closely you can see the seam between the 2 pieces.
The front sight base is installed/pinned after the FFT is installed. Instructions for unpinning the FSB can be found about 1/3 down the first page on this link. |
AR Sponsor