AR Sponsor
Posted: 10/13/2012 4:45:23 PM EDT
|
Hello All,
Been a member for some time but this is my first post. Lots of great information here. Hope to be able to contribute too as my knowledge increases. I installed a MI Gen2 fore end on my Del Ton DT Sport. It went in fine and seated perfectly at the front. My concern is that the delta ring is not square with the receiver. It is right up against the fore end at the top rail but it is closer to the receiver at the bottom rail. Is there any cause for concern here? Thanks. Rick |
|
Quoted:
Usually this is from the handguard not properly seating around the barrel nut. With the delta ring depressed, does the bottom section of hanguard sit flush against the top? Came here to say the same thing. My buddy had a Stag that had the same kind of issue. I just had to loosen up the set screw that held it in place and re seat it on the delta ring. Pics were certainly help though. ETA: The rail was a factory add on from stag. Not an MI rail. |
AR Sponsor