AR Sponsor
Posted: 7/2/2009 7:42:39 PM EDT
|
I can't find my answer in Magpul's literature. I have an A-2 but stock on my Bushy. Do I need a different extension for the CTR or will my stock one work? Thanks Again!
230JHP |
|
Quoted:
Quoted:
I can't find my answer in Magpul's literature. I have an A-2 but stock on my Bushy. Do I need a different extension for the CTR or will my stock one work? Thanks Again! 230JHP You need a carbine extension/buffer tube. Add to this that you will need a correct tube diameter extension tube depending on whether the CTR is commercial diameter or mlilitary specification diameter and you will also need an end plate, a securing castle nut, a carbine length recoil spring and a carbine length buffer and a special wrench for the castle nut. |
|
Quoted:
Here's a good set! Everything you need $55.95. http://www.bravocompanyusa.com/Stock-Hardware-Mounting-Kit-Mil-Spec-p/stock%20hardware%20kit.htm Be sure to check if the stock is Mil-spec, or commercial. http://www.magpul.com/pdfs/technotes/ctr/buffertubeid.pdf http://www.bravocompanyusa.com/Stock-Hardware-Mounting-Kit-Mil-Spec-p/stock%20hardware%20kit.htm Get this (the one in the link is mil-spec), your CTR stock (in mil-spec if you buy from the link), and make sure you order a castle nut wrench as Milo said or yuo're not going to get very far. |
|
Quoted:
Here's a good set! Everything you need $55.95. http://www.bravocompanyusa.com/Stock-Hardware-Mounting-Kit-Mil-Spec-p/stock%20hardware%20kit.htm Be sure to check if the stock is Mil-spec, or commercial. http://www.magpul.com/pdfs/technotes/ctr/buffertubeid.pdf I have the same kit from BCM and have no complaints... |
AR Sponsor