Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 1/25/2006 2:11:32 PM EDT
Provided I have this on a registered SBR lower, can I just have a 16-inch barrel cut down to 11 or 11.5 inches, with threading and expect the AR to cycle properly? I would really like to hear from people that have actually done their SBRs that way.

What about on a barrel like the one in the picture below? I realize this is perm-attached FH but what length is this barrel?



Link Posted: 1/25/2006 2:50:55 PM EDT
Link Posted: 1/25/2006 6:19:19 PM EDT
The gas port size is different for an 11.5" barrel than on a 16-incher. If you cut the barrel down to 11.5" (I would do this instead of 11"), you need the gas port enlarged to anywhere from .086" to .094" in diameter for proper function. There isn't a single gas port size to reference as it will depend on ammo selection to a large extent.

However, I would absolutely buy a factory 11.5" barrel rather than cut your 16" barrel. It will cost less to buy an new one and it will already be set up for proper function at 11.5" with a wide array of loads provided you buy from a reputible manufacturer. Similarly, you'll also be putting a lot of money into a used barrel when you could have a new barrel for less money and keep the 16" as a spare.

FYI- After you live with an SBR for awhile, you will discover reasons to shoot it with a Title I barrel, which is another reason to keep the 16" intact and in your possession. You draw lots of attention, which can be either fun or scary depending on your luck of the draw. Also some ranges will not allow the short barrel, even if legal. If an 11.5" is all you have, it's all you can do.
Link Posted: 1/25/2006 7:05:16 PM EDT
Commiefornia...

damian@adcofirearms.com
Top Top