AR Sponsor
Posted: 2/6/2011 7:02:33 AM EDT
|
I'm kinda anal about keeping the lower pin holes pristine over the long haul..........probably not necessary but.......well I have KNS anti-walk Gen 2 pins.
Problem is I have a couple of RRA Nat'l Match triggers and just found out that KNS says to use the .155 sized set only. So, I ordered some of them. How do I remove the KNS pins already installed by me in those two rifles? Is it basically the same as when I initially installed them? I wish the fu** I knew beforehand that RRA match triggers needed the .155 sized pins!! 
Thanks for any info. |
| Who installed the RR triggers originally? Were they installed with standard trigger and hammer pins or with the supplied oversize pins? If the pins are standard size, you can install the standard KNS. But honestly you don't really need them. I've installed RR two stages and used loctite to prevent standard pins from spinning without deforming my receivers and have not had any issues. |
|
Quoted:
Who installed the RR triggers originally? Were they installed with standard trigger and hammer pins or with the supplied oversize pins? If the pins are standard size, you can install the standard KNS. But honestly you don't really need them. I've installed RR two stages and used loctite to prevent standard pins from spinning without deforming my receivers and have not had any issues. I installed them and put the KNS stuff in afterwards.........like a DUMBA**.......I didn't know the pins that came with the RRA triggers were oversized. Plus, like a SUPER DUMBA**........I don't know where I put the original RRA pins. It's quite possible, like a SUPER DUPER DUMBA**........I threw the original RRA pins in the garbage!!
|
AR Sponsor