[ARCHIVED THREAD] - Questions About RRA Elite Comp.

Posted: 9/2/2009 1:00:57 PM EDT

Hello everyone. I just purchased the Elite Comp. I have a question about the front pivot retaining pin. It has such a tight fit. I need to tap it in and out using that yellow chamber flag. It's impossible to do by hand. Is this normal ? or out of spec ? Thanks.

Posted: 9/2/2009 1:04:02 PM EDT

[#1]

go out and shoot it as much as possible. it will loosen up.

Posted: 9/2/2009 1:40:17 PM EDT

[#2]

Try a lot of lube or grease in the holes as well. Tight pivot pins are not uncommon. I had a Noveske I had to use a hammer and punch on for a while until it loosened up.

[ARCHIVED THREAD] - Questions About RRA Elite Comp.

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Questions About RRA Elite Comp.

[ARCHIVED THREAD] - Questions About RRA Elite Comp.