AR Sponsor
Posted: 11/9/2008 4:49:34 PM EDT
|
I have a stag model 2 and am trying to install a rifle length yhm rail. I can't get the pins out of the fsb. Are they just in there super tight or am I doing something wrong? Has anyone else had this problem? It appears that the pins are in backwards, like to remove you would drive from right to left. I read somewhere that they could be that way.
cassidy bond |
| If the pins are tapered, one side should be smaller than the other, drive them from the small side. Try using a nail set with a dimpled end rather than a roll pin punch. You can expect it to take a significant amount of force to get the pins out, most companies use a hydraulic press to put them in. Use a good size hammer, and give it a good whack! Some folks have had to use small sledge hammers. You may also try putting some Kroil or WD40 on the pins and letting it set overnight. |
AR Sponsor