[ARCHIVED THREAD] - YHM question

Posted: 5/10/2008 7:11:38 PM EDT

I have a YHM Low profile gas block. here is what I got:

I'm considering getting a 9" or 10" Troy FF rail. I don't have a midleangth AR so I want the rail to slide over the gasblock.

My question is, will this fit under the Troy MRF-M or MRF-MX??? Does anyone have any experience with YHM blocks and what they fit under???

Here's a pic of the front end of the MRF series to give an idea:

Posted: 5/10/2008 7:19:57 PM EDT

[#1]

I know they don't fit under Larue Handguards. The Troy Handguards look about the same size.

Posted: 5/10/2008 9:19:18 PM EDT

[#2]

Really? they don't fit under the LT15s, that sucks. Does anyone know for sure if they fit under the Troy handguards? I contacted Troy and they said it would fit, I just want a second opinion to be sure.

Posted: 5/10/2008 9:25:00 PM EDT

[#3]

hey look at yhm's "YHM-9383". I have this one and my buddy has the Vltor. They look the same except the finish. Mine works flawless and fits under a Mi handguard. My buddy has a DD handguard and his vltor fits under that. I doubt any of this helps though because its not what you asked. BTW my gas block is only .75" long. Very short and small and cheaper!!! ALOT CHEAPER!

Posted: 5/11/2008 2:20:51 AM EDT

[#4]

Quoted:
Really? they don't fit under the LT15s, that sucks. Does anyone know for sure if they fit under the Troy handguards? I contacted Troy and they said it would fit, I just want a second opinion to be sure.

What better opinion are you looking for than the manufacturers opinion?

[ARCHIVED THREAD] - YHM question

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - YHM question

[ARCHIVED THREAD] - YHM question