I has gotten a DS lower back in '02 or '03 and finally got the funds for an RLL. I was wondering if they are RLL friendly before I go through the paperwork and forking out the cash?
Ken
Posted: 10/4/2007 1:40:21 PM EDT
[#1]
Do you have an overhead pic looking down into rear of the upright lower?
All so Anvil Arms and the lower with Shark on the side are low shelf.
Posted: 10/5/2007 1:14:00 PM EDT
[#4]
Here is a pic of the lower. Ya think she'd work?
Ken
Posted: 10/5/2007 1:22:30 PM EDT
[#5]
The shelf looks fine but I can't tell from the pic if the radius aft of the FCG area may be forward of where you need it. If so, you will just need to remove a little material with a dremel or have it milled out. Not a big deal!
Posted: 10/5/2007 1:56:01 PM EDT
[#6]
Quoted: Here is a pic of the lower. Ya think she'd work?
