[ARCHIVED THREAD] - Vortex flash hider installation

Posted: 1/27/2007 2:21:48 PM EDT

I want to replace the A2 Birdcage FH on my 6.8SPC with a Vortex. I have a spare Vortex for a Rem700 bolt rifle (.308cal). The thread pattern is the same as my 6.8SPC which is 5/8x24. I'm thinking I can just simply remove the birdcage, thread on the Vortex with a little red locktight and I should be good to go. The Vortex flashhiders do not require indexing so I think this should be a simple "do it yourself" job.

Any input or suggestions from experienced personal would be appreciated.

Thanks !

Posted: 1/27/2007 2:23:12 PM EDT

[#1]

No need for the locktite. The Vortex will self tighten.

Posted: 1/27/2007 2:37:19 PM EDT

[#2]

Like Al said no locktite. They are self tightening..
Also dont put in on very tight, I just put mine on as tight as I could with my hand and it has been fine. I f you want to use a wrench just tighten it by hand them do 1/8 of a turn with the wrench..
Good luck

Posted: 1/27/2007 5:19:30 PM EDT

[#3]

Sounds good.......Thanks !

Posted: 1/27/2007 6:09:37 PM EDT

[#4]

The above is correct for how to install the Vortex but standard thread for the AR15 is 1/2x28. So I think you are out of luck.

Seydou

Posted: 1/27/2007 6:11:56 PM EDT

[#5]

Quoted:
The above is correct for how to install the Vortex but standard thread for the AR15 is 1/2x28. So I think you are out of luck.

Seydou

He has one for a .308 that he is going to use on a 6.8 SPC. I think he is GTG

Posted: 1/27/2007 7:50:57 PM EDT

[#6]

Doh!

Posted: 1/28/2007 7:18:02 AM EDT

[#7]

6.8SPC barrels are threaded 5/8x24....same as Rem700 .30cal stuff. They are different from standard AR15 barrel threads so that someone does not accidentilly place a .223 device on a 6.8 barrel and .............KABOOM !!!!!!

[ARCHIVED THREAD] - Vortex flash hider installation

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Vortex flash hider installation

[ARCHIVED THREAD] - Vortex flash hider installation