AR Sponsor
Posted: 3/2/2006 3:12:54 PM EDT
|
What is the best way to remove the sear block from my Colt 6920 lower? I have the basic Dremel/Drill Press stuff but I don't want it to look like tried to scrape it out with a damn spoon or something. BTW who makes the Colt lowers? TIA |
|
It can be easily removed with a Dremel and a cutoff wheel(or two). Just cut into the block itself as close to the side as you dare to get, you have to cut both sides and cut down past the level of the pin. There is also a roll pin that sticks up into the bottom of the block so you will have to rock it back and forth a bit to get it out. Not hard at all. Have fun. After the offending object was removed  Where the pin used to be, I will put the heads of the pin back in the holes someday  the heads of the pin 
|
|
A milling machine is not required if you have the old sear block that is held in with pins. I have removed two with a dremil and the pins stay in place. There is no damage to the reciever, and you cant tell from the outside. Here is the link to the directions from the archive. I'm not sure that you can see it if you're not a member due to the thread being old. LOOK HERE |
Evidently, you didn't fully read the whole thread...  Or maybe you did and just dont know anything about the 6920 or 6721 LE models...
|
AR Sponsor
Win a FREE Membership!
Sign up for the ARFCOM weekly newsletter and be entered to win a free ARFCOM membership. One new winner* is announced every week!
You will receive an email every Friday morning featuring the latest chatter from the hottest topics, breaking news surrounding legislation, as well as exclusive deals only available to ARFCOM email subscribers.