Posted: 10/29/2016 6:20:44 PM EDT
| Trying to install a new G2S trigger. Took me all of 5 minutes up until I'm trying to get the hammer pin through that little clip on the right side of the hammer assembly. Just can't get the pin to slide through the clip. Tips? |
| I just installed one of these the other day. Make sure the ring is seated on the hammer, it while lightly *click* into place. Then give the pin a decent hit with a nylon hammer and it will get past the clip. Center the pin back up on the hole in the receiver and you should be able to push it through by hand at that point. |