Posted: 9/12/2011 9:47:45 PM EDT
|
I installed a SSF trigger in my RDIAS M16 today.
I noticed that the hammer spring that came with the SSF appears much stronger/heavier than my previous milspec spring. My RDIAS kinda likes the weaker spring. I found that the SSF hammer fits/works with a normal milspec hammer spring. Is it safe to use a milspec hammer spring instead of spring supplied from you???????????????????????????????????????? |
|
Well, it is safe to use the mil-spec spring ok. Problem is, your RDIAS should work with the heavier spring, which tells me that the RDIAS does not fit properly (not tight enough in the lower) allowing the hammer to "push" it out of correct position.
But, if it works with the weaker spring, then it is ok to use. 
|