Posted: 1/18/2010 9:51:12 AM EDT
| What is the best way to add a VFG to a 6920? Can I use the stock handguards? |
|
I'd personally get a Knight's RAS to mount a VFG on a 6920 which will be the more expensive route ($150.00). However, I believe someboday such as UTG manufactures a slightly tapered rail segment that allows the mounting of a VFG (at right-angle) on standard M4 hg's which would be the super cheap solution ($15.00). A low to moderate cost solution would be to get a set of Magpul Moe hg's and a rail segment from ergo ($40.00). I have probably missed a zillion other options however this is what quickly came to mind. Good luck.
Cheers |
|
You can buy just a section of rail, and mount it using the vent holes on the bottom of the handguard. It's the cheapest solution. But, it might still be a little wobbly. Ergo rails
Next up is the MOE HGs with the rail mounted to the bottom. There are, or were, handguards with a built in rail on the bottom. I don't recall the manufacturer off hand. Then insert your non-free float railed handguard of choice. Any of those is easy to do and doesn't require modification of the rifle. |
|
Fairly cheap option:
Get a Troy MRF-DI rail system. They can be had for just over $100 and are rock solid. I think I've tried every method of mounting a VFG via the plastic hand guards, but they were all pretty weak. If you really want to go that route, the GG&G Under Foregrip Mount was the best I found. You have a top tier rifle and I would go with a solid option if the bank account can accommodate. My $.02. 
|
|
Quoted:
What is the best way to add a VFG to a 6920? Can I use the stock handguards? Here are a few options you could consider which would allow you to mount a rail system and not have to modify your weapon (take anything apart). 1. Knight's Armament RAS 2. Knight's Armament RAS II 3. VLTOR CASV-M 4. ARMS Sir Yes, you can get a rail mount that attaches to your hand guards, but that's are real humpty dumpty IMHO. Here is what the VLTOR would look like on your 6920. Definitely a slick looking setup 
|
|
Quoted:
Quoted:
What is the best way to add a VFG to a 6920? Can I use the stock handguards? Here are a few options you could consider which would allow you to mount a rail system and not have to modify your weapon (take anything apart). 1. Knight's Armament RAS 2. Knight's Armament RAS II 3. VLTOR CASV-M 4. ARMS Sir Yes, you can get a rail mount that attaches to your hand guards, but that's are real humpty dumpty IMHO. Here is what the VLTOR would look like on your 6920. Definitely a slick looking setup
http://www.vltor.com/images/casv-m/CASV-M-4.jpg I'd rather have handguards and a rail segment over 3 of the 4 options that was indicated. YMMV. Also, image of CASV appears to be on a middy. Cheers |