[ARCHIVED THREAD] - Eotech Mount Question

Posted: 3/27/2008 1:36:10 PM EDT

Want to raise the Eo up to a lower 1/3 co-witness and run a Troy BUIS behind it. Any chance of an Eo mount WITHOUT the "piece-of-picatinny on the back"?

Posted: 3/27/2008 1:44:52 PM EDT

[#1]

Quoted:
Want to raise the Eo up to a lower 1/3 co-witness and run a Troy BUIS behind it. Any chance of an Eo mount WITHOUT the "piece-of-picatinny on the back"?

The troy works when mounted to the upper with the eotech riser in place.

Posted: 3/28/2008 3:35:08 AM EDT

[#2]

What benefit would removing the raised rail section provide?

Posted: 3/28/2008 4:08:45 AM EDT

[#3]

I understand the Troy already works with the existing LaRue Eo mount...I just do not want the Eo that far forward and sitting out over the delta ring. I'm running a 511 with the Troy and want to keep it all confined to just the upper receiver's pic rail...it's an OCD thing!

I want to keep it just like pictured only higher!

Posted: 3/28/2008 8:18:34 AM EDT

[#4]

if larue would make a rail for the LT17 thing, then you could do something like this:

[ARCHIVED THREAD] - Eotech Mount Question

Warning

Confirm Action

[ARCHIVED THREAD] - Eotech Mount Question

[ARCHIVED THREAD] - Eotech Mount Question