Posted: 11/9/2014 10:57:49 PM EDT
| So I have a Noveske 300blk 10.5" barrel. I have a 9" rail. I want the barrel to sit as close to the rail as possible. I want to also preserve the logo for future references. I measured the thread itself and from the end of the thread to the logo and its not long enough to cut and thread. It would have to chase the thread. How much do you guys charge for that? |
|
If you send us just the barrel, we can cut it to your requested length and thread it to spec for $65. If you are afraid you will lose an image on your barrel due to us properly cutting the threads, we cant help you.
If you just want to push the threads/shoulder back a bit, if you send just the barrel the cost is $85. |
|
Quoted:
If you send us just the barrel, we can cut it to your requested length and thread it to spec for $65. If you are afraid you will lose an image on your barrel due to us properly cutting the threads, we cant help you. If you just want to push the threads/shoulder back a bit, if you send just the barrel the cost is $85. Yeah if you cut the barrel and thread, I'm afraid the logo would be cut off. What do you mean push the thread and shoulder back? Like continue threading where they left off? If that's the case, it would work since I only wanted like .8" cut off. I measured the logo from the end of the thread and it measured about 1.1" and I knew if you guys cut right at the end of the thread and threaded the rest, it would eventually thread over the logo. |