TNVC: NEW and Exclusive Filmed SuperGain (FSG) Image Intensifier Tubes & Chimera Pano Giveaway!!

[ARCHIVED THREAD] - Pinning muzzle device

Posted: 1/22/2012 6:20:38 PM EDT

I have a 16". Midlength upper with an Adams arms piston system and dd omega x 9 inch rail. The Daniel defense barrel is threaded and I need a pws TTO compensator pinned and welded to be NYS AWB compliant. Given at I live in new York, I can't and havent test fired the upper.

My question is can it be test fired pre and post pin and weld to make sure it functions correctly?

Would there be an additional charge for this? (other then the $85 to pin the brake)

Thanks

Chris

Posted: 1/22/2012 6:35:46 PM EDT

[#1]

If all you are asking for is a couple of rounds, before and after, to make sure a bullet flies out the end and it cycles another round into the chamber, no problem.

Anything more comes with a charge and ammo cost.

Posted: 1/22/2012 7:00:20 PM EDT

[#2]

Thanks

That's all I was looking for.

Will have to place my order and ship it out.

I am debating having the barrel dimpled under the Adams arms gas block for the set screws as well.

Thanks again

[ARCHIVED THREAD] - Pinning muzzle device

Warning

Confirm Action

[ARCHIVED THREAD] - Pinning muzzle device

[ARCHIVED THREAD] - Pinning muzzle device