Posted: 5/8/2010 5:39:52 AM EDT
|
Would it be possible to shave the fsb on a Noveske mid length barrel and pin a fsb at the rifle length position for a dissipator set up? If so.. Are my calculations correct for the cost (130 for fsb pinning + 30 for shaving original fsb)?
Thanks.. Rob |
|
That is correct, as long as the new FSB area will accept a .750 FSB (diameter is big enough).
If it is not big enough, then you would need a contour FWD of gas block ($65) to .625, then you would need to supply a .625 FSB, then the FSB install would be $90 (instead of $130). Clear as mud, right. 
|
|
Quoted:
Reply from Noveske: The barrel is .68" from the front sight to the muzzle. Still doable? Well, you could use a .625 FSB. The barrel would need to be contoured from the muzzle to the FSB location, but yes, it is doable. Cost would be $65 for contour and $130 for FSB install (if only barrel sent). If sent as a complete upper, then a Dis/Re-assemble (std = $35, FF =$50) would be required as well.
|
