Posted: 11/17/2009 8:25:33 PM EDT
|
I was thinking about cutting down my spare 14.5 barrel to a 10.5, or an 11.5 length barrel. Which would you guys reccomend. I have also read that if I do go to a 10.5 barrel, then the gas port might have to be opened up a bit. Does that mean that I should remove the FSB before I send it to you all. If it helps the barrel would be used on a pistol build and mostly for plinking. Thanks for any help
Oh yeah, if I order some products from your website, can you all place them in the return box, or will they have to be shipped seperately. Thanks |
|
Either 10.5" or 11" is fine (not much difference to worry about). Yes, the gas port may need adjustment, and it is included in the cut/thread, if it is required. You can take the FSB off if you like, but if you are sending JUST the barrel assy in (minus upper receiver) then we will remove it for gas port adjust at no extra charge.
Any products purchased at the same time as Shop Service can be sent in the same box, as long as they are in stock. Just note it in the comments section, at checkout. 
|
|
Quoted:
Either 10.5" or 11" is fine (not much difference to worry about). Yes, the gas port may need adjustment, and it is included in the cut/thread, if it is required. You can take the FSB off if you like, but if you are sending JUST the barrel assy in (minus upper receiver) then we will remove it for gas port adjust at no extra charge. Any products purchased at the same time as Shop Service can be sent in the same box, as long as they are in stock. Just note it in the comments section, at checkout. Sweet Thanks alot guys for the quick response. |