Posted: 8/8/2009 1:46:52 PM EDT
|
I have this upper height gas block on an M4 profile barrel:
Gas Block Can you drill and pin it? The set screws seem to be holding up fine, but i would prefer to have it pinned as well. What would something like this cost and what would be the turnaround time? Thanks very much. |
|
[Mr. Burns] Excellent [/Mr. Burns]
Would you guys use a taper pin or a roll pin (my S&W uses a taper pin which I like but don't know if that is how they are all done)? It has 3 set screws, I would like 2 pins, one in each space between the screws. would that be complete overkill or would it be worth spending a little extra money to get 2 since you will already have it under the press? Sorry, I should have asked these questions in my OP. Thanks again! |
|
OK, if you say one pin is good, that is good enough for me.
I have the gas blocks on pretty darn straight, but do you check them before you pin them or will you just leave then where I have them? I assume I should remove the bolt carrier, charging handle and sights from the upper before I send it, right? Do I send it and then you bill me and then send it back? Do I check out on your web site and then send it? Thanks for your help! |