Posted: 4/27/2017 10:34:04 PM EDT
| Any chance you might start producing p320 grip modules? |
It's really too bad that glock magazines are too wide to fit in the p320 FCU. A Magpul grip module to accomodate gmags would be dopeAF, but it's impossible. 
As much as I'd love love love Magpul to make these, my guess is that unless SIG pays them to do it we are SOL. |
|
Quoted:
I emailed Magpul about this, and their response was basically "no comment" I hope they do. Then I'd finally pick a 320 up. Maybe they could even set up a factory model with SIG using the grips I'd like to see some different grip textures and a model that uses cheaper magazines would be amazing. |
|
I've been working in designing a P320 grip in SolidWorks to take different magazines. And it's going to have to be for a metal magazine like the S&W M&P mags or Beretta M9 mags. Because the polymer glock mags are too wide to get through the fire control unit, the top round needs to be presented high enough for the slide to be able to strip it out of the mag.
Among metal 9mm magazines, I expect that S&W M&P mags are the most common and least expensive. So I'm moving forward with that. |