Posted: 5/10/2010 7:48:58 AM EDT
| Wondering when we'll start seeing these in the usual colors, and if there's a window version in the works? |
|
It's been stated that just like the Ford Model T you can get these in any color you want, as long as it's black.
These are made for precision rifles primarily, I don't think a window is needed, same reason you don't see windowed 20 round 5.56. Worst case just paint the mag. |
|
Quoted:
krylon fusion works wonders.. THIS!! Depending on how tight the LR-20's fit in your lower now...I would advise taping off the portion of the mag that inserts into the magwell before you paint them. Too much paint + a tight mag/magwell = Problems (with dropping free, fitting properly, etc.). |
|
Quoted:
Does the dust cover clip onto the bottom of the 20LR like the M Revision 5.56 PMAG does? The first ones did but word is that they were so hard to get off and on that it was dropped. You can find some photos of the older versions with the notches built to allow that. |
|
Quoted:
Quoted:
Does the dust cover clip onto the bottom of the 20LR like the M Revision 5.56 PMAG does? The first ones did but word is that they were so hard to get off and on that it was dropped. You can find some photos of the older versions with the notches built to allow that. Ok, that clears it up. I had seen a few pics w/the notch, but knew that all the ones I've seen first hand didn't have them. Thanks! Anyone have a 1st gen PMAG 20LR w/the notches/dust cover clips on bottom they want to sell? 
|