I don't have one and need one, but they are nowhere to be found in my small town.
Anyone ever make a pin to hold the gas tube instead?
Posted: 10/31/2016 9:08:50 AM EDT
[#1]
FSB uses taper pins.
My bad, you need a gas tube roll pin, hardware store.
Posted: 10/31/2016 9:09:32 AM EDT
[#2]
you talking about the gas tube roll pin? in a pinch you can get an assortment of roll pins in various sizes from home depot or harbor freight or something. you'll need to shorten it, or not if its under a handguard.
Posted: 10/31/2016 9:12:42 AM EDT
[#3]
Jam a 5/64 drill bit in the hole
Posted: 10/31/2016 9:13:52 AM EDT
[#4]
tiny nail will hold it. Just bend the pointy side so it don't fall out.
Posted: 10/31/2016 9:21:11 AM EDT
[#5]
Miamishooter used a bent nail, works for him.
Posted: 10/31/2016 9:23:39 AM EDT
[#6]
J-B weld is the only answer.
Using the correct components is for suckers, evidently.
Posted: 10/31/2016 9:27:20 AM EDT
[#7]
I get mine at NAPA auto. Or whatever they call a auto parts store up there.
Posted: 10/31/2016 9:27:44 AM EDT
[#8]
Quote History
Quoted: J-B weld is the only answer.
Using the correct components is for suckers, evidently.
View Quote
Pretty low stress component, a finishing nail should be a suitable temporary fix.
Posted Via AR15.Com Mobile
Posted: 10/31/2016 9:29:50 AM EDT
[#9]
Quote History
Quoted: J-B weld is the only answer.
Using the correct components is for suckers, evidently.
View Quote
what do you think is so special about the one that comes with the fsb or gas tube (depending on manufacturer)
.