Posted: 11/29/2016 1:20:33 PM EDT
| Just ordered a Savage 10 FLCP and Im looking for a stock that can be used with DBM bottom metal to take AICS pattern mags. Open to all suggestions. Thanks. |
|
Quoted:
I put my 10 FP-SR in a Bell & Carlson M40 stock with the Accurate Mag bottom metal. I did not have to do anything to fit the bottom metal. I did have to get shorter action screws from the ones I was using with the Savage bottom metal. This appears to use proprietary Accurate Mag mag. Is that correct? |
|
Quoted:
This appears to use proprietary Accurate Mag mag. Is that correct? Quoted:
Quoted:
I put my 10 FP-SR in a Bell & Carlson M40 stock with the Accurate Mag bottom metal. I did not have to do anything to fit the bottom metal. I did have to get shorter action screws from the ones I was using with the Savage bottom metal. This appears to use proprietary Accurate Mag mag. Is that correct? No the Accurate Mag Bottom Metal is suppose to be AICS compatible. My MDT mags should be here today so I'll let you know how they fit. |
|
Attached File Savage 10 FP-SR (.223) with Bell & Carlson M40 stock Accurate Mag bottom metal and MDT 10 round poly mag Attached File Accurate Mag bottom metal. Had to use 1/4-28 x 1 3/4 and 1 1/8 cap screws for this set-up. Mags fit nice and tight. Fed and extracted great with the dummy rounds I ran through it. |
|
Quoted:
This was my reason for asking. I think I'll be going with a CDI bottom metal. They are supposed to be really good and will inlet your stock for free. I doubt CDI will inlet for free. Even at $60 and free shipping back it's a steal. Turn around is a week or less. I've had 2 done by CDI. Would do a third. |
|
They do infact inlett for free.
http://www.cdiprecisiongunworksstore.com/inletting-and-install-shop-services/ I also emailed to confirm and to see about having a stock sent to them directly. 
|