Posted: 12/13/2015 8:16:37 AM EDT
| I am working on Lg pockets and cutting to .1320 . My problem is the pockets are not squared when I am done there may always be a little left over is this ok ? Also I should note my brand new cutter from hornady is horribly running off center I plan I calling on Monday to get a replacement. |
|
So, do you mean the bottom of that .132 surface does not clean up all the way around?
That sounds wrong because that is the max dimension and if there are zones where a cutter set to 0.132 is still not cleaning it up, it would be out of tolerance. The range for that depth should run from 0.125 to 0.132. How deep below flush does a primer seat when you are done? |