Posted: 7/10/2014 10:16:11 AM EDT
| I'm new to the world of archery but I bought a Hoyt charger on monday. Ive got it sighted in at 20 yds, but i'd like to move the sight down and the pin up to the top of the sight so that i have enough room for the rest of my pins. The problem is that my sight is already as far down as it goes, what should i do? Thanks |
|
What size pins are you using? I shoot a Hoyt Carbon and a PSE DNA. Both have the same issue as well. I had to swap them out for .10 pins to open the gap. The other option is a single pin sight. I just ordered one of these to test it out. http://archerxtreme.com/products/item/x-driver-1-pin/ |
|
It could also be due to arrow rest height and/or nocking point height.
The rest height should be set so that the arrow shaft passes in front of the Berger Hole (arrow rest bolt hole), or just slightly higher than that. The nocking point on the string should be about even with or slightly higher (1/4 - 3/4") than the center of the Berger Hole. Helps to have a bow square to check the nock height. This is called "centershot." If you find that the bow won't tune fairly close to the centershot, then you probably need to press the bow and begin adjusting the cable and string lengths to adjust the yoke angle and cam timing to get it tuned. |