Posted: 12/16/2004 12:45:32 PM EDT
|
I recently purchased a 6520 LGC Lower it does not use the mill-spec take down pin with detent and spring. It has small hole unlike my SP1. My question is does anyone know where to purchase a take-down pin that is small dia. and with a single screw right side is made to fit lower fence enhacement. I've seen them listed somewhere but can't remember where. Thanks for any assistance.... _________________________________________________ BoyScout4Life, Semper Fi. |
|
Have you tried SAW? Here's a link to their page, www.sawlesales.com/ Look through the Colt Rifle Parts section although you'll have to scroll the parts list to find one. I'd bet its there Good luck |
|
I don't know if this is what you are takhing about, but I bought a takedown pin for my Colt from DSA. I think they have two models. One for the large hole Colts and the one I have for the small hole Colts. I like it. It is different, but it works. <http://www.dsarms.com/item-detail.cfm?ID=KNS250&storeid=1&image=ARPBTDPIN.gif> |
I've got one off of my Colt R6601, I replaced it with a standard (.125") Mil-Spec pin. Is yours drilled for a standard pin? Drain hole in mag fence is a good indication. What's holding it together now? |
|
Thats an idea BOOMER but with my luck I'd drill the hole to deep and have to look for a longer spring! Na, want to keep all orginal. To previous post as stated I pur- chased LE lower all alone from P.D. take-offs. Does not have drain hole, solid forge. ____________________________ BoyScout4Life. |