These are pics from the REAL source of SPRs, I was only invited for the weekend, these have nothing to do with me or adco.
If you see a pic of an SPR in action, this is where it came from, and what it went through.
Lots of little things done to test/prep the barrel, and other small parts but that’s boring........
Gotta have barrels
And upper receivers
Torque, check and retorque the barrel nut
Install the gas block and gas tube
Install the locking pins for the FF RAS
Tighten the screws on the gas block
Install the OPS INC collar
Snug up the OPS INC brake
Uppers ready to test fire(note lack of fancy bolt carrier)
Load the mags
Locate the targets, 12” steel plates 340yds into the woods, through the leaves.
Bore sight? Nope, a team scope works just fine, follow the trace and correct as necessary.
Looking at the shooting position from the target area.
After a successful test firing, the OPS thread protector is installed and they are ready to go.