Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 12/20/2003 1:53:11 PM EST
Hi, just wanted to share my finished project, which is a hipower built on an feg frame with mostly browning parts. Has anyone else done this?

btw, my second project is the 2-tone here, I just need sights to finish it:

Link Posted: 12/21/2003 4:17:51 AM EST
I didn't go quite that far on my FEG, just the extractor that finally wore out and the garish oversize white dotted rear sight had to go.
I would like a "Capitan" slide, just for looks.
Nice photos, BTW.
It looks like you retained the magazine disconnect safety, from the pictures the trigger pins look untouched.
You do know about the obligatory range report, don't cha?
Link Posted: 12/21/2003 5:16:36 AM EST
Remove the magazine disconnect --- I feel it improves trigger pull, and makes the weapon more tactical.

Link Posted: 12/21/2003 5:25:13 AM EST
Looks good so far, Total investment?($$$$)
Link Posted: 12/21/2003 6:14:20 AM EST
total investment so far

feg pjk-9hp (complete) $169 with two hicaps (mecgars!)
feg pjk-9hp (frame with browning fire control parts) $125 shipped.
complete blued browning slide, barrel and guide rod $100
browning slide, stripped $30
parts to finish both from sarco. $179

total so far $603, just need sights to finish the second one.

BTW, on the mag disconnect, I always put the pin back in when I do take out the spring.
Top Top