Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 8/19/2006 8:11:13 AM EDT
I was putting my factory extended slide stop into my G19 and I noticed as I was trying to put the pins back in that the end of the spring extended into the channel for the top pin. Now using my old slide stop I could work the end of the spring either under or over the pin. I was just wondering, should it be under, over, or not even be having this problem.

Joe
Link Posted: 8/19/2006 2:51:35 PM EDT
Link Posted: 8/19/2006 3:12:39 PM EDT
One of the things to remember is the "Locking Block Pin"(#3) is the first pin to be removed and the first pin to be installed.

Link Posted: 8/19/2006 9:11:49 PM EDT
Got it. Knew this was the place to turn to. Now Im just waiting on my extended mag release, AGrip, and M3 Tac Light and my G19 is complete
Link Posted: 8/20/2006 4:36:19 PM EDT
Link Posted: 8/22/2006 7:03:40 PM EDT

What, no 3.5 lb connector?????


I put that in at the same time as my extended slide stop

Then I get to take it all apart again when I get my extended mag release.
Top Top