Here's mine:
Beretta 92g Elite II
www.citlink.net/~lmiller/alessi03big.jpgThis pistol was modified for my CCW weapon and duty weapon.
The work was done by LTT.
-Bevel job
-Teflon coated frame and small parts by TTI
-Bar-sto 4.7" gunsmith fit stainless barrel, hand fitted locking block
-Level II trigger job 8 lbs DA / 4 lbs SA, with a Black speed bump trigger
-Spurless hammer
-Novak night sights, .290 rear
-CTC 302 Laser grips
-Harrts mercury filled guide rod
-Shok buffs installed
-Black hexnut grip screws
The holster I use for CCW pictured above is a Lou Alessi ACP/s in black shark skin. I have a belt, mag carriers and light pouch that match. The buckle on the belt is a 3 piece sterling set.
www.citlink.net/~lmiller/alessibeltbig.jpgThis weapon has about 5000 - 7000 rounds through it at the moment, and there is absolutely no wear on it. Not even on the frame rails. The finish around the very edge of the mag well has worn through. The first day I had this pistol, I wore through the brut. finish through most of the magwell. The Teflon coating after the break in has made this thing very durable. The only wear present is on the decocker levers.
If I had it all over to do again, I'd do a few things differently. I would have had Birdsong coat the frame and small parts in Black-T teflon. I would have used a .305 rear tritium novak night sight. I would attempt to get different color lamps in the rear too. I've considered a semi-ghost ring with a bar dot. If a Wilson combat pyramid would fit, I'd probably get that.
I'd track down a set of CTC grips with the Beretta logo instead.
It has been a very good gun. I hope to get a whole lot more high cap mags in less than a month.
-Steve