[ARCHIVED THREAD] - Extended Slide Stop

Posted: 6/20/2008 4:05:06 AM EDT

I am trying to install an extended slide stop in a 2 pin G17. Will the newer stops work (without the little cutout like the one I am replacing)? It looks like the stop goes too high and forward when an empty magazine is inserted. Thanks!

Posted: 6/20/2008 4:52:09 AM EDT

[#1]

Quoted:
..... Will the newer stops work .....!

No, the 2 pin G17 has a limiter built onto the slide stop lever.

2pin

3pin

Posted: 6/20/2008 6:03:37 AM EDT

[#2]

Is there an extended stop for a 2 pin?

Posted: 6/20/2008 7:10:15 AM EDT

[#3]

I was looking for an extended slide lock a couple weeks ago for my 3 pin G20, and all
my local shop had was one for a 2 pin.
I compared the 2 pin extended slide lock with the 3 pin standard slidelock, and found both to have basically the same dimensions.
I filed off that shark fin and smoothened it out, It's works beautifully with "0" problems.

Posted: 6/20/2008 7:32:35 AM EDT

[#4]

I did the same with my G20. Snipped of the fin and filed the area down flush and smooth.

-p

Posted: 6/20/2008 7:34:54 AM EDT

[#5]

I need one with the fin though.

Posted: 6/20/2008 12:06:46 PM EDT

[#6]

I actually have one in my spare parts box. I'll send you a PM.

Posted: 6/20/2008 1:21:33 PM EDT

[#7]

Quoted:
Is there an extended stop for a 2 pin?

Yes, as stated above.

[ARCHIVED THREAD] - Extended Slide Stop

Warning

Confirm Action

[ARCHIVED THREAD] - Extended Slide Stop

[ARCHIVED THREAD] - Extended Slide Stop