Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 10/17/2004 1:33:58 PM EST
may have asked these before but I'm haveing a little bit of a brain fart, so I'll ask again just incase I didn't the first time....

How do you form the front site, if you build a semi out of a STEN Mark 3 parts kit?....

Does anyone sell rolled steel recievers (blank or whole....) like the origionals?....

How tricky is it to assemble a parts kit into a semi?....

How much if any welding is reqiured, and if there is welding would solder work instead?....

Does anyone sell 100% completed recievers?....

What parts have to be modified and in what way?....

Do I have to replace any parts with US made ones to comply with 922r, if so which ones, and where can I get them?....

Did any actual millitary issue STEN Mark 3 have the wire pistol grip that I see from some vendors in loo of a stock?....

If I use the pistol grip instead of the stock can I call it a pistol and use the standard length barrel, and would the pistol grip have to be perminantly attached?....

What is the overal length of the Sten Mark 3 with the 16 inch barrel and standard wire loop stock, and whats the overall length of it with the T stock?.... (Michigan has a stupid law that says any rifle with an overall length of less than 30 inches has to be registered as a pistol, and anything under I think 26 inches is an SBR and not allowed....)

Is there any longer barrel extentions available?....

What parts in the STEN Mark 3 are differant than the Mark 2?....
Top Top