Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/27/2006 8:12:24 AM EST
I used a kit to finish my stripped lower, I was really impressed by how easy it was, but now I am thinking I might have screwed something up.

The pin that the trigger rided on was moving and was working its way out of the receiver about every 20 rounds. The hammer spring should keep it in place, but I guess its just not holding it? Too much CLP in that area???

Any fixes for this?
Link Posted: 3/27/2006 8:15:06 AM EST
E-Clips?
Link Posted: 3/27/2006 8:15:58 AM EST
KNS Pins???

They look cool too.....
Link Posted: 3/27/2006 8:16:37 AM EST

Originally Posted By 1911greg:
Any fixes for this?



You could try the build it yourself forum.
Link Posted: 3/27/2006 8:16:45 AM EST
spring may be upside down.

that was my problem
Link Posted: 3/27/2006 8:20:45 AM EST
i think you are right, is the spring suppose to go on top of the trigger pin or below it?
Link Posted: 3/27/2006 8:25:05 AM EST

Originally Posted By BayEagle:
spring may be upside down.

that was my problem



Same here.
Link Posted: 3/27/2006 8:28:36 AM EST


The tail of the HAMMER spring goes in the groove (on top) of the trigger pivot pin.

Your welcome.
Link Posted: 3/27/2006 8:32:46 AM EST

Originally Posted By Waldo:

The tail of the HAMMER spring goes in the groove (on top) of the trigger pivot pin.

Your welcome.



hmmm im pretty sure thats how i have it any pic...

its on top but maybe not in the groove?
Link Posted: 3/27/2006 8:39:54 AM EST

Originally Posted By 1911greg:

its on top but maybe not in the groove?



There is a drawing in the TM.

Since it's homebuilt, it's possible the hole is oversized. The proper way is to drill it undersize and then use an exact size reamer to finish.

Link Posted: 3/27/2006 8:42:08 AM EST
shoops i am pretty sure I put the spring in upside down
Link Posted: 3/27/2006 8:54:30 AM EST


Link Posted: 3/27/2006 9:07:35 AM EST

Originally Posted By Waldo:

The tail of the HAMMER spring goes in the groove (on top) of the trigger pivot pin.

Your You're welcome.



Indeed! Something is not right if the pin is walking out.

Leave the KNS pins to the internut commandouches.
Link Posted: 3/27/2006 10:52:28 AM EST
thanks for the help guys! I cannot remember can I simply just drive out the hammer pin left to right?
Link Posted: 3/27/2006 11:01:28 AM EST
[Last Edit: 3/27/2006 11:05:01 AM EST by warlord]

Originally Posted By 1911greg:
thanks for the help guys! I cannot remember can I simply just drive out the hammer pin left to right?


I don't think it would matter which way you push those pins holding the trigger group in. You can just push it out with your fingers, and a sturdy plastic/wooden rod of some-sort. The pins are held in place by the spring pressure inside the trigger group.
Top Top