Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 1/2/2003 3:11:23 PM EST
Aybody try one of the Grease mag coversion units from Top Notch?How did it work for you?Did you install it yourself?Any info would be greatly appreciated.
43E1P
Link Posted: 1/9/2003 5:43:22 AM EST
[Last Edit: 1/9/2003 5:45:06 AM EST by JTR]
I have it on my USC. Fit / finish is great. Works flawlessly after switching to roll pins. (they send them to you free). I would like an ambi mag release though, which doesn't seem like it would be hard to do. . . . Anyway, loosing the botl hold open to get the ability to use 30 rnds $10 mags is a good deal I think.


Edited to add: Yes, I installed it myself. It wasn't too hard.

-Justin

Link Posted: 1/10/2003 11:18:01 AM EST
Been thinking of this conversion myself, can you put the stock lower back on and still have the bolt hold open, and function like the stock gun? Do you have to modify the upper in any way? Do you need to but it through an FFL?


Thanks in advance JBhunter
Link Posted: 1/10/2003 1:15:03 PM EST
Yes, you can put the stock lower back on and it'll be right back to how it was. Bolt hold open and all. You DO have to modify the upper. You need to shave between 1/16 and 1/8 of an inch off the inside of the hole the mag goes through, or else the mag won't go in. It is minor, easy, and doesn't effect the gun any. You do not need to go through an FFL, as the UPPER on a USC is the firearm. The lower is nothing.

Later,
Justin

Top Top