Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 1/13/2006 12:42:55 PM EDT
I have a M77 in .280 cal. The problem is with factory bullets when I load a shell and then eject it without firing, it pulls the bullet out of the case. Is there something wrong with the chamber? It does it on all brands of bullets. All are factory loads.
Link Posted: 1/14/2006 7:08:54 PM EDT
I would assume that the throat of the chamber is either short, really dirty or rough from corrosion. I would pollish it a bit and try again. A gun smith with a bore scope could tell you what is going on for sure.
Link Posted: 1/16/2006 6:47:28 AM EDT
The gun is new and the barrel is stainless, I know it can still corrode, but it isnt dirty, if the throat is too short, how do I fix it.
Link Posted: 1/16/2006 8:29:14 AM EDT

Originally Posted By badshooter:
The gun is new and the barrel is stainless, I know it can still corrode, but it isnt dirty, if the throat is too short, how do I fix it.




CALL RUGER AND HAVE THEM FIX IT !! Their customer service is excellent, and it should be a problem for them to do this.
Link Posted: 1/16/2006 4:36:21 PM EDT
Have you tried diff types of factory ammo?
Link Posted: 1/17/2006 5:44:37 PM EDT

Originally Posted By RobarSR60:

CALL RUGER AND HAVE THEM FIX IT !!





I wonder if they didn't screw up & put the wrong barrel in???????????
Top Top