Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
Armory Sponsor
5/5/2016 4:31:34 PM EDT
Does anyone still make these? I have a MAG Tactical (recently gone belly-up) lower with extra material around the pin holes for added strength.



The required dimensions seem to be 5/32 x 1 1/8 inches as opposed to the normal 5/32 x 7/8 inch.

5/5/2016 4:38:10 PM EDT
[#1]
You can still use standard pins, too - they'll just have slightly recessed ends.
5/5/2016 4:56:02 PM EDT
[#2]
I would probably buy some of the low cost anti walk pins off of Amazon, then put slightly longer screws in to capture them.
5/5/2016 7:36:04 PM EDT
[#3]
Pins from a K&N set?
5/5/2016 7:54:57 PM EDT
[#4]
Quote History
Quoted:
Pins from a K&N set?
View Quote

This appears to be the only option. Thanks all.
5/22/2016 1:50:51 PM EDT
[#5]
Olympic arms used to sell a set of anti walk pins that were just longer pins with a groove cut in the end for an "e" clip
5/25/2016 2:14:48 PM EDT
[#6]
I just spoke with FosTecH in Seymour, Indiana. They seem to have acquired some of MAG Tactical's assets and actually have these pins in stock.

5/25/2016 7:30:20 PM EDT
[#7]
good deal, it's nice when things work out like that! might buy a couple just in case.



Bruce
Armory Sponsor