Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 8/11/2010 5:57:55 PM EST
They are all under max case length, should I worry about trimming? Or should I trim them all down to a universal length for consistency?
Link Posted: 8/11/2010 6:06:07 PM EST
[Last Edit: 8/11/2010 6:06:47 PM EST by AeroE]
Link Posted: 8/11/2010 7:08:39 PM EST
Link Posted: 8/11/2010 7:13:05 PM EST
You say they are all under max length? If it's for plinking, don't bother. If for matches, trim all to same length.
Link Posted: 8/11/2010 7:48:10 PM EST
[Last Edit: 8/11/2010 7:48:34 PM EST by Boosted98gsx]
Originally Posted By dryflash3:
I would trim after sizing, then debur. Depends on your trimming method, and what kind of loads you will use them for.

If I were going to use them for precession loads, I would also uniform the PP's and debur the flashole.

As far a safety is concerned, if they are less than 1.761, no need to trim.

They will be for 77gr SMK "match" loads. Which for me, are pretty much just .5 MOA plinking rounds. I don't have a PP uniformer, but I do debur the flash hole.
Link Posted: 9/11/2010 4:19:57 PM EST
Just want to validate this, If I want to make precision loads, I should trim to mmaximum uniform OAL?
Top Top