Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 9/24/2004 2:51:12 PM EST
I have some finish missing from the round indention where the stock meets the lower, just below the buffer tube. It is not exposed when the stock is on. The lock plate covers it. Should I worry about it or just touch it up? It looks like the finish kind of missed a nail head size secion when it was being applied.
Link Posted: 9/24/2004 3:34:25 PM EST
throw some CLP over it, reinstall the stock and dont worry about it.
Link Posted: 9/24/2004 4:23:21 PM EST

Originally Posted By huey_crew_chief:
I have some finish missing from the round indention where the stock meets the lower, just below the buffer tube. It is not exposed when the stock is on. The lock plate covers it. Should I worry about it or just touch it up? It looks like the finish kind of missed a nail head size secion when it was being applied.



The reason it's that way is because of the way they hung the receiver on the fixture during anodizing. They had the receiver, with that hole aiming down, and a air pocket was left behind during the anodizing process. Is seen this many times before.

Link Posted: 9/24/2004 5:11:48 PM EST
that explains it! Thanks alot! Dave
Link Posted: 9/24/2004 5:39:33 PM EST
Why did you buy it with part of it unfinished?
Link Posted: 9/24/2004 9:45:02 PM EST



____________________________________
The only hope you have is to accept the fact that you are already dead. And the sooner you accept that, the sooner you will be able to function as a soldier is supposed to function, without mercy, without compassion, without remorse.
Link Posted: 9/25/2004 6:04:37 AM EST
Why did you buy it with part of it unfinished?

Because I fould it after I took off the buttsock to change it out.
Top Top